stationary phase raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
This page was last updated on 2026-02-03 and is reviewed periodically as new material appears.
Routine quality control monitors retention time shifts, baseline noise, system pressure, and peak shape. Trends can reveal column aging, mobile phase preparation errors, detector drift, or sample degradation. Corrective actions may include replacing the column, preparing fresh mobile phase, or recalibrating the detector. Stability testing often uses HPLC to measure parent compound loss and degradation product formation. Open questions remain about how accelerated stability results extrapolate to long-term storage under varied conditions.
Quality control for HPLC testing combines scheduled checks, documented procedures, and review of results. Before sample analysis, system suitability testing confirms that the instrument, column, and method meet predefined criteria. Common criteria include resolution between critical peaks, retention time precision, peak tailing, and theoretical plate count. Failure triggers investigation before results are reported. Records link raw data, calculations, instrument logs, and analyst identity to each batch, supporting audits and repeat analysis.
Method validation evaluates accuracy, precision, specificity, linearity, range, detection limit, quantitation limit, and robustness. Regulatory guidance for pharmaceuticals, foods, and environmental testing defines expected documentation and acceptance criteria. Verification confirms that a validated method works in a specific laboratory with its own instruments and reagents. Calibration curves use reference standards with known purity and traceability, while measurement uncertainty is estimated from validation data, control charts, and collaborative studies. The scope of validation depends on the method's intended use.
Routine quality control uses system suitability, blank injections, check standards, and control samples to detect drift or contamination. System suitability criteria may specify minimum resolution, maximum tailing factor, and a permitted range for repeated injections. Blank injections reveal carryover or solvent contamination, while check standards confirm calibration accuracy over a batch. Control samples with known analyte levels can show whether results remain within statistical limits. When a control result falls outside limits, the analyst investigates the cause and may invalidate affected results before repeating the batch.
Documentation and traceability are central to regulated HPLC testing. Records typically include instrument logs, column history, mobile-phase preparation, sample preparation, injection sequences, raw chromatograms, and audit trails. Electronic systems may require user access controls, time-stamped changes, and backup procedures. Training records show that analysts are qualified for assigned methods. Audits and inspections check whether written procedures match actual practice and whether deviations are documented. These controls support reproducibility and allow results to be reconstructed if questions arise later.
| Property | Value | Notes |
|---|---|---|
| Retention time RSD | ≤1% for five replicate injections | Typical criterion; method-specific limits apply. |
| Resolution | ≥1.5 between critical pair | Baseline separation is generally desired. |
| Tailing factor | ≤2.0 | Measures peak symmetry. |
| Theoretical plates | ≥2000 per column | Method-dependent; higher values indicate greater efficiency. |
| Peak area RSD | ≤2% for replicate injections | Reflects autosampler and detector precision. |
High-performance liquid chromatography is an analytical technique that separates components of a liquid sample by passing it through a packed column under pressure. A pump delivers a mobile phase at a controlled flow rate, and an injector introduces the sample into the stream. Differences in interaction with the stationary phase cause analytes to migrate at different rates. Detectors record elution as peaks, and a data system converts signals into a chromatogram. The method is suited to compounds that dissolve in a liquid and are not volatile enough for gas chromatography.
Reversed-phase chromatography dominates modern HPLC testing, using a nonpolar stationary phase such as chemically bonded octadecyl groups and a polar mobile phase of water mixed with organic solvent. Analytes partition between the mobile and stationary phases according to hydrophobicity. Gradient elution changes the mobile phase composition over time to separate compounds with a wide range of retention. Isocratic elution keeps the composition constant and is simpler for routine assays. Column temperature, pH, and flow rate influence selectivity, peak shape, and retention time, so these parameters are controlled during a validated method.
Separation in HPLC depends on the chemistry of the stationary phase, the composition of the mobile phase, and the physical properties of the column. Reverse-phase separations use a nonpolar stationary phase and a polar mobile phase, and they are common for many organic compounds. Ion-exchange, size-exclusion, and normal-phase modes serve other classes of analytes. Gradient elution changes solvent strength over time, while isocratic elution holds it constant. Flow rate, temperature, particle size, and column length all influence peak shape and resolution. Detection may use ultraviolet absorbance, fluorescence, refractive index, or mass spectrometry, depending on the analyte and the required sensitivity.
Routine HPLC testing compares a sample result with a calibration curve prepared from known reference standards. Peak area or peak height is plotted against concentration, and the curve is used to estimate unknown amounts. Retention time supports tentative identification when compared with a standard, though mass spectrometry or another confirmatory method may be needed for definitive identification. Pre-run checks verify repeatability, resolution, and peak symmetry before sample analysis. Limits of detection and quantification describe the smallest amounts that can be reliably observed or measured. Sample preparation, filtration, and degassing help prevent column damage and inconsistent results.
High-performance liquid chromatography is an analytical technique that separates components in a liquid sample. A pump moves a liquid mobile phase through a column packed with a solid stationary phase. Compounds interact differently with both phases and travel at different rates, leaving the column at distinct retention times. A detector records these arrivals as peaks on a chromatogram. The resulting pattern supports identification and quantification of substances in mixtures. Modern instruments use high pressure to force solvent through small particles, which improves speed and resolution compared with older low-pressure liquid chromatography methods.
=== Toll Holdings === In 1985, Little, along with businessmen Peter Rowsthorn as well as Rowsthorn's son, Mark Rowsthorn, and Lyall McLachlan, led a management buyout team which purchased Toll Holdings which in 1993 listed on the Australian Securities Exchange. Little and his team developed Toll from an 18-truck operation worth $1.5 million, into a $3.8 billion international organisation with 45,000 employees and operations in 50 countries. As a result of his involvement in Toll Holdings, Little has become one of Australia's richest men. Little subsequently further developed his ability to acquire new businesses, buying many between 1989 and 2000. He then began taking over two companies a year until 1997, when Toll paid $145 million for eight TNT businesses. In 2000, it paid $120 million for rival Finemore Holdings. Little also oversaw Toll's investments in technology, wine, rail freight and cargo shipping.
=== Vedolizumab === Vedolizumab is very similar to natalizumab in that it is a humanized IgG monoclonal antibody, but vedolizumab is an IgG1 that specifically blocks the alpha 4 beta 7 integrin that is located primarily on cells in the gastrointestinal tract. It is promoted as being gut specific due to the localization of alpha 4 beta 7 integrin in the gastrointestinal tract and was the first biologic to be made specifically for inflammatory bowel disease.
It is also possible to translate either by hand (for short sequences) or by computer (after first programming one appropriately, see section below); this allows biologists and chemists to draw out the primary amino acid sequence of the encoded protein on paper. First, convert each template DNA base to its RNA complement (note that the complement of A is now U), as shown below. Note that the template strand of the DNA is the one the RNA is polymerized against; the other DNA strand would be the same as the RNA, but with thymine instead of uracil.
=== Menopausal hot flashes === In 2013, low-dose paroxetine was approved in the US for the treatment of moderate-to-severe vasomotor symptoms such as hot flashes and night sweats associated with menopause. At the low dose used for menopausal hot flashes, side effects are similar to placebo and dose tapering is not required for discontinuation.
Sources: en.wikipedia.org
This is significant because any patient with tardive dyskinesia was specifically excluded from randomization to perphenazine; i.e., in the CATIE study the patient cohort randomized to receive perphenazine was at lower risk of having extrapyramidal symptoms. Atypical antipsychotics do not appear to lead to improved rates of medication adherence compared to typical antipsychotics. Many researchers question the first-line prescribing of atypicals over typicals, and some even question the distinction between the two classes. In contrast, other researchers point to the significantly higher risk of tardive dyskinesia and other extrapyramidal symptoms with the typicals and for this reason alone recommend first-line treatment with the atypicals, notwithstanding a greater propensity for metabolic adverse effects in the latter. The UK government organization NICE recently revised its recommendation favoring atypicals, to advise that the choice should be an individual one based on the particular profiles of the individual drug and on the patient's preferences. The re-evaluation of the evidence has not necessarily slowed the bias toward prescribing the atypicals.
== Function == Urocanic acid is found in animal sweat and skin. its concentration varies greatly between people, from 4 nM per cm2 to 34 nM per cm2 with only small differences between areas other than at the sole of the foot and between sun-exposed and unexposed areas. Concentration does not link with age, sex, skin tone, photosensitivity, and stratum corneum thickness. Among other functions, urocanic acid acts as an endogenous sunscreen or photoprotectant against UVB-induced DNA damage. However, some studies have questioned this. Urocanic acid is found predominantly in the stratum corneum of the skin and it is likely that most of it is derived from filaggrin catabolism (a histidine-rich protein). When exposed to UVB irradiation, trans-urocanic acid is converted in vitro and in vivo to cis-urocanic acid (cis-UCA). The cis form is known to activate regulatory T cells. Measuring cis-UCA provides a sensitive means at sub-erythemal doses to detect UVB, and so offers a potential method to assess the UVR protection provided by suncreams. Some studies attribute filaggrin an important role in keeping the skin surface slightly acidic, through a breaking down mechanism to form histidine and subsequently trans-urocanic acid, however others have shown that the filaggrin–histidine–urocanic acid cascade is not essential for skin acidification.
=== Development and rationale === The TOPS System was developed in the early 2000s, with the concept of facet joint replacement introduced by biomedical engineer Uri Arnin. The idea was based on clinical observations that many patients undergoing lumbar spinal fusion have preserved intervertebral discs with degenerative spine pathology affecting the posterior elements of the vertebrae, including spinal stenosis, spondylolisthesis, and facet arthrosis. This led to the development of a motion-preserving alternative to fusion designed to maintain spinal stability following decompression. The first clinical implantations were performed in 2005, followed by international clinical use and subsequent randomized controlled trials comparing the device with fusion.
Sources: en.wikipedia.org
Homebake (or home-bake) is a slang name most commonly used in Australia, and New Zealand for non-prescription opioids. The term refers to a crude mix of opioid class of drugs such as heroin, morphine and monoacetylated derivatives produced from pharmaceutical morphine tablets or morphine that has been produced through the demethylation of codeine when it is difficult to obtain heroin.
=== Physical activity === Weight loss may improve MASLD and is recommended particularly for obese or overweight people; similar physical activities and diets are advisable for overweight people with MASLD as for other obese and overweight people. Although physical activity is less important for weight loss than dietary adaptations (to reduce caloric intake), the NICE advises physical activity to reduce liver fat even if there is no overall bodyweight reduction. Weight loss, through exercise or diet, is the most effective way to reduce liver fat and help MASH and fibrosis remission. Exercise alone can prevent or reduce hepatic steatosis, but it remains unknown whether it can improve all other aspects of the liver; hence a combined approach with diet and exercise is advised. Aerobic exercise may be more effective than resistance training, although there are contradictory results. Vigorous training is preferable to moderate training, as only the high-intensity exercise reduced the chances of MASLD developing into MASH or advanced fibrosis. The EASL recommends between 150 and 200 min/week in 3 to 5 sessions of moderate-intensity aerobic physical activity or resistance training. Since both effectively reduce liver fat, a pragmatic approach to physical activity that accounts for the individual's preferences for a sustainable physical activity that they can maintain long-term is preferred. Any increase in physical activity over previous levels is better than remaining sedentary.
== Management == There is currently no cure for PFBC nor a standard course of treatment. The available treatment is directed symptomatic control. If parkinsonian features develop, there is generally poor response to levodopa therapy. Case reports have suggested that haloperidol or lithium carbonate may help with psychotic symptoms. One case report described an improvement with the use of a bisphosphonate.
The Spanish American wars of independence (Spanish: Guerras de independencia hispanoamericanas) were a series of conflicts across the Spanish Empire in the early 19th century. They began shortly after the outbreak of the Peninsular War and formed part of the broader Napoleonic Wars. The process unfolded in two main phases. First, the Spanish Monarchy broke up, beginning in Spain in 1808 with the invasion by the French Empire, the Spanish uprising against the Bonapartes, the vacancy of the throne, and the emergence of juntas later replicated in America. This unfolded as it did because the monarchy's basic cellular structure was the cabildo (town council, or ayuntamiento). Second, attempts at reconstruction failed and became a war in their own right: Cádiz sought a pan-Hispanic state, Ferdinand VII sought to restore the Crown returned to him by Napoleon, and in the Americas Bolívar, Iturbide and others tried to build large federations or empires. The result was the fragmentation of the Hispanic world into multiple states that largely reconstituted the old Spanish administrative boundaries under uti possidetis. The conflicts were multilateral, involving factions grouped into two camps: Royalists, who favoured continued Spanish rule, and Patriots, who supported independent monarchies or republics separate from Spain and from one another. They led to the independence of most of Spanish America and, through Balkanization, to Hispanic America. Defined strictly by military campaigns, they ran from the 1809 Battle of Chacaltaya (Bolivia) to the 1829 Battle of Tampico (Mexico).
Sources: en.wikipedia.org
System suitability is typically performed before each batch or according to the validated method and laboratory procedure. Some long runs include periodic checks during analysis. The required frequency depends on regulatory expectations and method performance.
Retention time drift can result from changes in mobile phase composition, column temperature, pump flow, or column age. A gradual shift often points to column degradation. A sudden shift may indicate a leak, mixing error, or incorrect mobile phase.
Retention time alone cannot confirm identity because different compounds may elute at similar times. Coupling HPLC with mass spectrometry or comparing against authenticated standards increases confidence. Confirmation usually requires orthogonal data.
Validation establishes suitability for a new method, while verification confirms that a method works in a specific laboratory. Verification is often used when a validated method is adopted with existing equipment and staff. Both rely on documented acceptance criteria.