This is a working overview of retention time, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2025-12-29. Anything still debated is marked as such rather than presented as settled.
Most routine HPLC testing uses reversed-phase columns, where the stationary phase is nonpolar and the mobile phase is a polar mixture such as water with an organic solvent. Analytes partition between the two phases according to polarity, size, and charge. Gradients that change solvent composition over time can separate compounds with broad retention ranges. Isocratic conditions keep solvent composition constant and suit simpler mixtures. The choice of column chemistry, pH, and temperature affects selectivity and peak shape.
Detection in HPLC testing commonly relies on ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. UV detection is widely used because many organic compounds absorb light, but it requires a chromophore. Mass spectrometry provides mass-based identification and high sensitivity for trace analytes. Each detector has trade-offs in selectivity, cost, and compatibility with mobile phases. Quantification typically uses calibration curves prepared from reference standards. Results are reported as concentration, purity, or presence above a limit.
HPLC testing is an analytical technique used to separate, identify, and quantify components in a liquid sample. It relies on a pressurized mobile phase that carries the sample through a column packed with stationary phase. Different compounds travel at different rates because of interactions with the stationary and mobile phases. The resulting signal versus time is a chromatogram. Peak position indicates identity under specified conditions, while peak area or height relates to amount.
Laboratories apply HPLC testing across pharmaceutical, food, environmental, and industrial chemistry. The method can measure active ingredients, impurities, additives, preservatives, and degradation products. Sample preparation often includes dilution, filtration, and sometimes extraction or derivatization. The choice of column, mobile phase, pH, temperature, and detector depends on the analytes and matrix. Results are compared with reference standards to assign identity and concentration. Method suitability is judged by resolution, precision, and accuracy.
| Property | Value | Notes |
|---|---|---|
| Separation mode | Reversed-phase | Nonpolar stationary phase with polar mobile phase |
| Typical column particle size | 3–5 µm | Smaller particles improve resolution but raise pressure |
| Typical flow rate | 0.5–2.0 mL/min | Depends on column dimensions and pressure limits |
| Common detection | UV-Vis absorbance | Requires analytes with chromophores |
| Typical run time | 5–30 min | Varies with method, gradient, and sample complexity |
Instrumentation includes a solvent delivery system, an autosampler, a column oven, and one or more detectors. Reversed-phase columns with chemically modified silica are widely used, but normal-phase, ion-exchange, size-exclusion, and affinity modes exist for specific separations. Detectors may rely on ultraviolet absorbance, fluorescence, refractive index, or mass spectrometry. Column temperature, mobile phase composition, and flow rate are adjusted to improve resolution. System pressure is monitored because rising pressure can indicate column blockage or deteriorating packing.
Separation performance depends on particle size, pore size, column length, and the chemistry of the stationary phase. Smaller particles generally improve efficiency but require higher pressure and suitable instrumentation. The mobile phase often contains buffers and organic solvents that influence retention and selectivity. Testing labs select conditions based on the analytes, sample matrix, and required sensitivity. Method development frequently involves screening several columns and solvent mixtures before a final set of conditions is chosen.
High-performance liquid chromatography is an analytical technique that separates components in a liquid sample by passing them through a packed column under pressure. A pump delivers a mobile phase at a controlled flow rate, and an injector introduces the sample into the stream. Differences in how analytes partition between the mobile phase and the stationary phase cause them to exit the column at different times. Detection then records a signal proportional to the amount of each separated substance. The resulting chromatogram provides retention times and peak areas for identification and quantification.
High-performance liquid chromatography, or HPLC, separates dissolved compounds by passing a liquid mobile phase through a packed column. Components distribute differently between the stationary phase and the moving liquid, so they travel at different speeds and exit at different times. A detector records these eluting bands as peaks, and peak area or height relates to amount. The technique supports testing in pharmaceuticals, foods, environmental samples, and industrial chemicals. Quantification usually depends on calibration with known standards.
Several separation modes exist, including reversed-phase, normal-phase, ion-exchange, size-exclusion, and hydrophilic interaction liquid chromatography. Reversed-phase uses a nonpolar stationary phase with a polar mobile phase and is widely applied to small organic molecules. Gradient elution changes mobile phase composition during the run, while isocratic elution keeps it constant. Column chemistry, particle size, temperature, flow rate, and mobile phase pH all influence retention and resolution. Method development selects conditions that separate analytes from matrix components and from each other.
Detection commonly uses ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. Ultraviolet detection depends on molecular chromophores that absorb light at specific wavelengths. Mass spectrometry provides mass information and sensitive quantification, often after electrospray ionization. Before sample batches, performance checks examine resolution, elution time repeatability, peak symmetry, and plate count. Matrix effects and co-elution remain recognized uncertainties; formal validation studies and orthogonal detection help address them. Detector choice depends on analyte properties and required sensitivity.
Separation modes differ by the chemistry of the stationary phase and the composition of the mobile phase. Reversed-phase testing uses a nonpolar column and polar solvents, making it common for pharmaceutical, environmental, and food analytes. Normal-phase testing uses a polar column and nonpolar solvents for compounds that are poorly retained in reversed-phase systems. Ion-exchange and ion-pair methods separate charged species, while size-exclusion methods sort molecules by hydrodynamic volume. Gradient elution changes solvent strength over time to resolve complex mixtures, and isocratic elution holds solvent composition constant for simpler assays.
Key performance measures include retention time, peak area, peak height, resolution, tailing factor, and plate count. Retention time helps identify a peak under fixed conditions, but confirmation often requires a second method or detector. Peak area and height relate to concentration through calibration curves, which may be linear or nonlinear depending on the detector response. Resolution describes separation between adjacent peaks, while tailing factor and plate count describe peak shape and column efficiency. Performance checks verify these values before and during a run to confirm that the instrument is performing within limits.
High-performance liquid chromatography testing separates components of a liquid sample by forcing a mobile phase through a packed column. The stationary phase inside the column interacts with analytes to different degrees, so each compound exits at a characteristic retention time. A pump delivers solvent at controlled flow and pressure, while an injector introduces a precise sample volume. Detectors such as ultraviolet-visible, fluorescence, refractive index, or mass spectrometric instruments record the separated bands. The resulting chromatogram provides qualitative and quantitative information about the mixture.
Such designers included Dave McDermott, who initially ran the Sven Co-op website before becoming a developer of it. Fearon had planned from the onset to include support for cooperatively playing through Half-Life's single-player campaign within Sven Co-op, but this was hampered initially by how the game's engine transitions from map to map, and made it difficult to keep players together in the multiplayer approach. Ultimately, the team was able to work this out, and later added support for Half-Life's two expansions, Half-Life: Opposing Force, and Half-Life: Blue Shift. Around 2004, prior to the release of Half-Life 2, Fearon had been planning to release Sven Co-op on Steam, but didn't due to confusion between the Sven Co-op team and Valve. Further, Fearon and the team had started work on a Sven Co-op 2 in anticipation of using the Source engine from Half-Life 2. Though they had developed a large number of assets for the mod, they were hindered by the lack of the SDK, which had been pushed back along with the release of Half-Life 2. Many of the team members had started to move on to other projects, and Fearon found they lost too many key members to continue development. Around this point Fearon opted to leave the project, giving the project lead over to Josh Polito. McDermott and Polito began negotiations with Valve to gain access to the GoldSrc engine around 2010 and to have Valve change some of the numerical limits originally imposed in the engine's use in Half-Life that would enable them to improve Sven Co-op.
Within the United States, the Patient Protection and Affordable Care Act of 2010 created an abbreviated approval pathway for biological products shown to be biosimilar to, or interchangeable with, an FDA-licensed reference biological product. Researchers are optimistic that the introduction of biosimilars will reduce medical expenses to patients and the healthcare system.
Evidence from the study of the pelvis and hindlimbs of Cyonasua, indicative of morphological similarities to bones of scansorial and terrestrial generalist carnivorans such as members of the genera Galictis, Meles and Arctictis, is presented by Tarquini et al. (2026). Tseng (2026) describes the first known partial skeleton of Leptarctus wortmani from the Hemphillian strata from the Rome Beds (Oregon, United States), providing evidence of morphology of the postcranial skeleton similar to those of extant badgers belonging to the genus Meles. Lopatin et al. (2026) describe a molar of a member of the genus Mellivora from the Pleistocene strata from the Tham Hai Cave, representing the first known record of Mellivorinae in Southeast Asia. A new specimen of Cernictis hesperus, providing new information on the anatomy of members of this species, is described from the (probably late Hemphillian) strata of the Pinole Tuff Formation (California, United States) by Tseng (2026). A well-preserved cranium of a Pleistocene sable is described from the Ogorokha Site (Sakha Republic, Russia) by Boeskorov et al. (2026). Sotnikova et al. (2026) report the discovery of new fossil material of large-bodied wolverines from the Pleistocene strata from the Indigirka River basin and New Siberia (Sakha Republic, Russia), and interpret their large size as likely to be physiological adaptation to the mammoth steppe environment. Rule et al.
Sources: en.wikipedia.org
Plutonium-238, curium-244, strontium-90, and most recently americium-241 are the most often cited candidate isotopes, but 43 more isotopes out of approximately 1,300 were considered at the beginning in the 1950s. The table below does not necessarily give power densities for the pure material but for a chemically inert form. For actinides this is of little concern as their oxides are usually inert enough (and can be transformed into ceramics further increasing their stability), but for alkali metals and alkaline earth metals like caesium or strontium respectively, relatively complex (and heavy) chemical compounds have to be used. For example, strontium is commonly used as strontium titanate in RTGs, which increases molar mass by about a factor of 2. Furthermore, depending on the source, isotopic purity may not be obtainable. Plutonium extracted from spent nuclear fuel has a low share of Pu-238, so plutonium-238 for use in RTGs is usually purpose-made by neutron irradiation of neptunium-237, further raising costs. Caesium in fission products is almost equal parts Cs-135 and Cs-137, plus significant amounts of stable Cs-133 and, in "young" spent fuel, short lived Cs-134. If isotope separation, a costly and time-consuming process, is to be avoided, this has to be factored in, too. While historically RTGs have been rather small, there is in theory nothing preventing RTGs from reaching into the megawattthermal range of power.
==== Reaction with compounds containing active methylene groups ==== In the presence of alkoxides, reactions of ethylene oxide with compounds containing active methylene group leads to the formation of butyrolactones:
What I feel is that I have a Jewish mind, I have a Jewish intelligence. I feel linked to previous Jewish minds of the past. I don't know what kind of trouble this gets somebody into, a disputatious mind. What a Jew is has been made by the experience of 5,000 years, that's what shapes the Jewish sense of humour, that's what shaped Jewish pugnacity or tenaciousness." Jacobson expressed concern over antisemitism in the Labour Party under Jeremy Corbyn's leadership. Ruth Prawer Jhabvala novelist and screenwriter Gabriel Josipovici novelist and short story writer Ben Judah (born 1988) British journalist and the author of This Is London and Fragile Empire;son of author Tim Judah; of Baghdadi Jewish descent; was a policy fellow in London at the European Council on Foreign Relations; has also been a visiting fellow at the European Stability Initiative in Istanbul; was a research fellow at the Hudson Institute in Washington D.C. In 2020, he joined the Atlantic Council in Washington D.C. as a Nonresident Senior Fellow. Judah has written for various progressive and conservative think-tanks including The Center For American Progress (CAP) and Policy Exchange. Tim Judah (born 31 March 1962) is a British writer of Iraqi Jewish ancestry, reporter and political analyst for The Economist.
The monocyte monolayer assay (MMA) is used to determine the clinical significance of alloantibodies produced by blood transfusion recipients. The assay is used to assess the potential for intravascular hemolysis when incompatible cellular blood products are transfused to the anemic patient. When donor cells possess substances that are not produced by the recipient, the recipient's immune system produces antibodies against the substance; these are called alloantibodies. Specific white blood cells, called monocytes, are tasked with ingesting foreign material and become activated during certain inflammatory events. These activated monocytes come in contact with antibody-sensitized red blood cells (RBC) and may or may not exhibit phagocytosis (ingestion) and destroy the donor red blood cells. If monocytes destroy the RBC, the antibody attached to those RBC is considered clinically significant.
Sources: en.wikipedia.org
Use of naloxone to treat people who have been using opioids recreationally may cause acute opioid withdrawal with distressing physiological symptoms such as shivering, tachycardia, and nausea; these in turn may lead to aggression and reluctance to receive further treatment.
== External links == Clinical trial number NCT02257567 for "A Study of Polatuzumab Vedotin (DCDS4501A) in Combination With Rituximab or Obinutuzumab Plus Bendamustine in Participants With Relapsed or Refractory Follicular or Diffuse Large B-Cell Lymphoma" at ClinicalTrials.gov Clinical trial number NCT03274492 for "A Study Comparing the Efficacy and Safety of Polatuzumab Vedotin With Rituximab-Cyclophosphamide, Doxorubicin, and Prednisone (R-CHP) Versus Rituximab-Cyclophosphamide, Doxorubicin, Vincristine, and Prednisone (R-CHOP) in Participants With Diffuse Large B-Cell Lymphoma (POLARIX)" at ClinicalTrials.gov
===== Acrididae ===== Locust swarming is initiated but not maintained by serotonin, with release being triggered by tactile contact between individuals. This transforms social preference from aversion to a gregarious state that enables coherent groups. Learning in flies and honeybees is affected by the presence of serotonin.
Sources: en.wikipedia.org
It separates components in a liquid sample and measures their amounts using a detector. Results can indicate concentration, purity, or identity based on retention time and detector response. The technique works for mixtures that can be dissolved and filtered.
It offers high resolution, reproducibility, and compatibility with many sample types. A single run can separate and quantify multiple analytes. It is common in pharmaceutical, food, environmental, and industrial laboratories.
Samples must be soluble in a suitable mobile phase and free of particles that can block the column. Detector response depends on analyte structure, so some compounds need derivatization or alternative detection. Complex matrices may require extensive sample preparation.
It measures the presence and amount of one or more compounds in a liquid sample. Separation occurs in a column, and detection produces a signal proportional to concentration. Identification usually requires comparison with a known reference standard under the same conditions.