HPLC raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
Reviewed 2026-05-09. Anything still debated is marked as such rather than presented as settled.
High-performance liquid chromatography, or HPLC, separates dissolved compounds by passing a liquid mobile phase through a packed column. Components distribute differently between the stationary phase and the moving liquid, so they travel at different speeds and exit at different times. A detector records these eluting bands as peaks, and peak area or height relates to amount. The technique supports testing in pharmaceuticals, foods, environmental samples, and industrial chemicals. Quantification usually depends on calibration with known standards.
Several separation modes exist, including reversed-phase, normal-phase, ion-exchange, size-exclusion, and hydrophilic interaction liquid chromatography. Reversed-phase uses a nonpolar stationary phase with a polar mobile phase and is widely applied to small organic molecules. Gradient elution changes mobile phase composition during the run, while isocratic elution keeps it constant. Column chemistry, particle size, temperature, flow rate, and mobile phase pH all influence retention and resolution. Method development selects conditions that separate analytes from matrix components and from each other.
Method validation establishes that an HPLC procedure is suitable for its intended purpose. Typical parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, robustness, and solution stability. Accuracy reflects closeness to a reference value, while precision reflects agreement among repeated measurements. Specificity shows whether the method can measure the analyte without interference from matrix components. Validation is documented through protocols and reports, and the required extent depends on the method's use and regulatory context.
Routine quality control uses system suitability, blank injections, check standards, and control samples to detect drift or contamination. System suitability criteria may specify minimum resolution, maximum tailing factor, and a permitted range for repeated injections. Blank injections reveal carryover or solvent contamination, while check standards confirm calibration accuracy over a batch. Control samples with known analyte levels can show whether results remain within statistical limits. When a control result falls outside limits, the analyst investigates the cause and may invalidate affected results before repeating the batch.
| Property | Value | Notes |
|---|---|---|
| Column particle size | 3–5 µm for conventional HPLC; sub-2 µm for UHPLC | Smaller particles increase backpressure and efficiency. |
| Typical flow rate | 0.5–2.0 mL/min for a 4.6 mm internal diameter column | Flow scales with column diameter and particle size. |
| UV detection wavelength | 190–400 nm | Selection depends on analyte chromophore. |
| Column temperature | 25–40 °C | Temperature affects retention, selectivity, and pressure. |
| Injection volume | 1–20 µL | Larger volumes may distort early-eluting peaks. |
Method validation establishes that an HPLC procedure is suitable for its intended use. Key parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Accuracy measures agreement with a true or accepted value, while precision describes repeatability and intermediate precision. Specificity confirms that the method measures the analyte without interference from impurities, degradants, or excipients. Validation is documented in a protocol and report, and acceptance criteria are set before experiments begin. Regulatory guidance varies by region, but the general principles are widely harmonized.
System suitability testing is performed before and during analytical runs to confirm that the instrument and method are working as expected. Common checks include retention time, peak area, resolution between critical pairs, tailing factor, and theoretical plate count. Results are compared with predefined limits, and a failed check requires investigation before sample results are reported. Quality control samples at low, middle, and high concentrations are injected at intervals to monitor accuracy and precision. Blank injections detect carryover and contamination, while control charts track performance over time.
Most routine HPLC testing uses reversed-phase columns, where the stationary phase is nonpolar and the mobile phase is a polar mixture such as water with an organic solvent. Analytes partition between the two phases according to polarity, size, and charge. Gradients that change solvent composition over time can separate compounds with broad retention ranges. Isocratic conditions keep solvent composition constant and suit simpler mixtures. The choice of column chemistry, pH, and temperature affects selectivity and peak shape.
Detection in HPLC testing commonly relies on ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. UV detection is widely used because many organic compounds absorb light, but it requires a chromophore. Mass spectrometry provides mass-based identification and high sensitivity for trace analytes. Each detector has trade-offs in selectivity, cost, and compatibility with mobile phases. Quantification typically uses calibration curves prepared from reference standards. Results are reported as concentration, purity, or presence above a limit.
=== Refinements === Cornelis Van Niel made key discoveries explaining the chemistry of photosynthesis. By studying purple sulfur bacteria and green bacteria, he was the first to demonstrate that photosynthesis is a light-dependent redox reaction in which hydrogen reduces (donates its atoms as electrons and protons to) carbon dioxide. Robert Emerson discovered two light reactions by testing plant productivity using different wavelengths of light. With the red alone, the light reactions were suppressed. When blue and red were combined, the output was much more substantial. Thus, there were two photosystems, one absorbing up to 600 nm wavelengths, the other up to 700 nm. The former is known as PSII, the latter is PSI. PSI contains only chlorophyll "a", PSII contains primarily chlorophyll "a" with most of the available chlorophyll "b", among other pigments. These include phycobilins, which are the red and blue pigments of red and blue algae, respectively, and fucoxanthol for brown algae and diatoms. The process is most productive when the absorption of quanta is equal in both PSII and PSI, assuring that input energy from the antenna complex is divided between the PSI and PSII systems, which in turn powers the photochemistry. Robert Hill thought that a complex of reactions consisted of an intermediate to cytochrome b6 (now a plastoquinone), and that another was from cytochrome f to a step in the carbohydrate-generating mechanisms. These are linked by plastoquinone, which does require energy to reduce cytochrome f.
Off-label prescription of HGH is controversial and may be illegal. Claims for GH as an anti-aging treatment date back to 1990 when the New England Journal of Medicine published a study wherein GH was used to treat 12 men over 60. At the conclusion of the study, all the men showed statistically significant increases in lean body mass and bone mineral density, while the control group did not. The authors of the study noted that these improvements were the opposite of the changes that would normally occur over a 10- to 20-year aging period. Despite the fact the authors at no time claimed that GH had reversed the aging process itself, their results were misinterpreted as indicating that GH is an effective anti-aging agent. This has led to organizations such as the controversial American Academy of Anti-Aging Medicine promoting the use of this hormone as an "anti-aging agent". A Stanford University School of Medicine meta-analysis of clinical studies on the subject published in early 2007 showed that the application of GH on healthy elderly patients increased muscle by about 2 kg and decreased body fat by the same amount. However, these were the only positive effects from taking GH. No other critical factors were affected, such as bone density, cholesterol levels, lipid measurements, maximal oxygen consumption, or any other factor that would indicate increased fitness. Researchers also did not discover any gain in muscle strength, which led them to believe that GH merely let the body store more water in the muscles rather than increase muscle growth.
==== Central America ==== The countries of Central America – Belize, Costa Rica, El Salvador, Guatemala, Honduras, Nicaragua, and Panama – are major transit and storage points for drugs headed to Mexico and the US that annually appear on the American "majors list". The US has had varying levels of direct anti-drug involvement in each of these countries, particularly since the late 2000s when concern over trafficking activity increased. Beginning in 2008, the Central America Regional Security Initiative (CARSI) has provided the seven countries with equipment, training, and technical support for law enforcement efforts, and the US has advised taking an intelligence-based approach. During the 1980s civil war in Nicaragua, the drug situation was intertwined with the US backing of the anti-leftist rebel force known as the Contras. Senator John Kerry's 1988 Senate Committee on Foreign Relations report on Contra drug links concluded that members of the State Department "who provided support for the Contras are involved in drug trafficking ... and elements of the Contras themselves knowingly receive financial and material assistance from drug traffickers." The involvement included payments to drug traffickers from funds authorized by the Congress for humanitarian assistance to the Contras, in some cases after the traffickers had been indicted by federal law enforcement agencies on drug charges, in others while traffickers were under active investigation by these same agencies."
Sources: en.wikipedia.org
H. Lundbeck Novo LEO Pharma Coloplast Dansac (owner Hollister Inc) Novozymes Pharma Nord Pharmacosmos ALK-Abelló Genmab RosePharma Santaris Pharma A/S Veloxis Pharmaceuticals Zealand Pharma Retail Salling Group (retail business) Coop Danmark, (part of the multi-sector Coop amba, formerly known as FDB until 2013) Dagrofa Transport A. P. Moller-Maersk Group (Maersk – conglomerate: shipping) Blue Water Shipping DFDS DSV Scan Global Logistics USTC (conglomerate: shipping, trading) Miscellaneous ISS (facility services) The Lego Group, as of 2014 the world's largest toy manufacturer by sales (in the first half of 2015, it made $2.1 billion in sales) Terma A/S, aerospace and defense
=== Linker === Between the reactive group and the tag, ABPs often include a linker / spacer / biorecognition element, which can tune probe solubility, steric accessibility, and substrate mimicry. Simple linkers may consist of alkyl chains or polyethylene glycol (PEG) spacers which adjust hydrophobicity and improve labeling across diverse proteomes. More complex designs incorporate biorecognition elements which can impart enzyme family or subfamily selectivity. For example, substrate-mimetic phosphonates have been used to target specific serine proteases and optimized peptide sequences can discriminate caspase isoforms. Binding or targeting motifs within the linker can further enhance interactions with enzymes whose active sites impose structural constraints, thereby improving probe specificity. In addition, linker length and composition can modulate probe permeability and distribution in cellular or in vivo contexts. This component allows probe designers to balance breadth (profiling an entire enzyme class) versus specificity (targeting individual members).
In 1958, Korolev upgraded the R-7 to be able to launch a 400-kilogram (880 lb) payload to the Moon. The Luna program began with three failed secret 1958 attempts to launch Luna E-1-class impactor probes. The fourth attempt, Luna 1, launched successfully on January 2, 1959, but missed the Moon. The fifth attempt on June 18 also failed at launch. The 390-kilogram (860 lb) Luna 2 successfully impacted the Moon on September 14, 1959. The 278.5-kilogram (614 lb) Luna 3 successfully flew by the Moon and sent back pictures of its far side on October 7, 1959. The US first embarked on the Pioneer program in 1958 by launching the first probe, albeit ending in failure. A subsequent probe named Pioneer 1 was launched with the intention of orbiting the Moon only to result in a partial mission success when it reached an apogee of 113,800 km before falling back to Earth. The missions of Pioneer 2 and Pioneer 3 failed whereas Pioneer 4 had one partially successful lunar flyby in March 1959.
Sources: en.wikipedia.org
Uterine prolapse occurs when there is a disruption to any of the structures mentioned above that help hold the uterus in place. Weakening of the levator ani muscles can occur during vaginal childbirth, in which portions of the muscle can detach from the bony pelvis, or through age-related changes to musculature, and this can lead to a loss of support for the uterus. Pregnancy, vaginal childbirth, or injury can also stretch and weaken the uterosacral ligaments, leading to poor suspension or positioning of the uterus so that it is no longer supported by pelvic floor muscles. Problems with the vaginal wall, such as trauma or loss of smooth muscle support in the wall, can lead to the uterus collapsing downward due to a loss of support. When the uterus prolapses, it also drags the upper portion of the vagina (the apical vagina) along with it due to its anatomic relationship with the apical vagina. Additionally, the pelvic musculature and connective tissues are estrogen sensitive and respond to changes in estrogen level. Estrogen deficiency, which can occur during menopause, can affect the production of collagen that is needed to build connective tissue that makes up ligaments and fascia, which can contribute to uterine prolapse. This is also a reason that connective tissue disorders can predispose certain people to uterine prolapse.
== As a bioassay == Organisation for Economic Co-operation and Development and U.S. Environmental Protection Agency (US EPA) guidelines describe toxicity testing using L. gibba or L. minor as test organisms. Both of these species have been studied extensively for use in phytotoxicity tests. Genetic variability in responses to toxicants can occur in Lemna, and data are insufficient to recommend a specific clone for testing. The US EPA test uses aseptic technique. The OECD test is not conducted axenically, but steps are taken at stages during the test procedure to keep contamination by other organisms to a minimum. Depending on the objectives of the test and the regulatory requirements, testing may be performed with renewal (semistatic and flow-through) or without renewal (static) of the test solution. Renewal is useful for substances that are rapidly lost from solution as a result of volatilisation, photodegradation, precipitation, or biodegradation.
=== Aqueous state and biochemical work === In 1972, along with Raj V. Gupta, Redfield found a way to cancel out the overwhelming signature spectrum of H₂O in biological samples, which allowed the visualization of molecular biological structure in blood cells, nucleic acids, enzymes, and phospholipids.
=== Diagnosis of infections === Clinical features of a respiratory tract infection may include initial symptoms of an upper respiratory tract infection mimicking a viral infection, usually associated with low-grade fevers. This may progress to the lower respiratory tract within a few days, with features often resembling those of wheezy bronchitis. Sputum may be difficult to expectorate and is often grey or creamy in color. The cough may persist for weeks without appropriate treatment. Many cases are diagnosed after presenting chest infections that do not respond to penicillins or first-generation cephalosporins. A chest X-ray can identify alveolar consolidation. Clinical diagnosis of invasive H. influenzae infection (infection that has spread to the bloodstream and internal tissues) is typically confirmed by bacterial culture, latex particle agglutination tests, or polymerase chain reaction tests on clinical samples obtained from an otherwise sterile body site. In this respect, H. influenzae cultured from the nasopharyngeal cavity or throat would not indicate H. influenzae disease, because these sites are colonized in disease-free individuals. Although highly specific, bacterial culture of H. influenzae lacks sensitivity. Use of antibiotics prior to sample collection greatly reduces the isolation rate by killing the bacteria before identification is possible. Recent work has shown that H. influenzae uses a highly specialized spectrum of nutrients where lactate is a preferred carbon source.
Sources: en.wikipedia.org
HPLC separates and quantifies compounds in a liquid sample. Detectors produce a response proportional to the amount of a compound passing through the flow cell. Identification by retention time requires comparison with a known standard.
UHPLC uses columns with smaller particles and operates at higher pressures than conventional HPLC. These conditions can improve speed, resolution, and sensitivity. Both techniques use the same fundamental separation principles.
Validation shows that a method performs reliably for its intended purpose across a defined range. It assesses accuracy, precision, specificity, linearity, and robustness. Regulated testing often requires documented validation before routine use.
Validation establishes suitability for a new method, while verification confirms that a method works in a specific laboratory. Verification is often used when a validated method is adopted with existing equipment and staff. Both rely on documented acceptance criteria.