The short version of quality control fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-12-20 and is reviewed periodically as new material appears.
Laboratories apply HPLC testing across pharmaceutical, food, environmental, and industrial chemistry. The method can measure active ingredients, impurities, additives, preservatives, and degradation products. Sample preparation often includes dilution, filtration, and sometimes extraction or derivatization. The choice of column, mobile phase, pH, temperature, and detector depends on the analytes and matrix. Results are compared with reference standards to assign identity and concentration. Method suitability is judged by resolution, precision, and accuracy.
HPLC testing is not a single fixed procedure; it is a family of separation modes. Reversed-phase, normal-phase, ion-exchange, size-exclusion, and affinity chromatography each suit different analyte properties. Reversed-phase methods dominate because they handle many neutral and moderately polar compounds. Detection can be optical, electrochemical, or mass spectrometric, and the detector dictates what information is available. Coupling with mass spectrometry increases selectivity and enables identification when standards are unavailable. The technique cannot separate every mixture without adjustment.
Routine quality control monitors retention time shifts, baseline noise, system pressure, and peak shape. Trends can reveal column aging, mobile phase preparation errors, detector drift, or sample degradation. Corrective actions may include replacing the column, preparing fresh mobile phase, or recalibrating the detector. Stability testing often uses HPLC to measure parent compound loss and degradation product formation. Open questions remain about how accelerated stability results extrapolate to long-term storage under varied conditions.
Quality control for HPLC testing combines scheduled checks, documented procedures, and review of results. Before sample analysis, system suitability testing confirms that the instrument, column, and method meet predefined criteria. Common criteria include resolution between critical peaks, retention time precision, peak tailing, and theoretical plate count. Failure triggers investigation before results are reported. Records link raw data, calculations, instrument logs, and analyst identity to each batch, supporting audits and repeat analysis.
Method validation evaluates accuracy, precision, specificity, linearity, range, detection limit, quantitation limit, and robustness. Regulatory guidance for pharmaceuticals, foods, and environmental testing defines expected documentation and acceptance criteria. Verification confirms that a validated method works in a specific laboratory with its own instruments and reagents. Calibration curves use reference standards with known purity and traceability, while measurement uncertainty is estimated from validation data, control charts, and collaborative studies. The scope of validation depends on the method's intended use.
| Property | Value | Notes |
|---|---|---|
| Abbreviation | HPLC | Also called high-performance liquid chromatography |
| Separation mechanism | Differential partitioning | Compounds distribute between mobile and stationary phases |
| Typical column chemistry | C18 (octadecylsilane) | Used in reversed-phase separations |
| Typical detector | UV-Vis or photodiode array | Mass spectrometry is common for trace and confirmatory work |
| Typical particle size | 1.8–5 µm | Smaller particles require higher pressure and can improve speed |
Data handling and documentation are central to HPLC quality control. Electronic systems should have audit trails that record changes to methods, sequences, and results. Integration parameters, such as peak baseline and threshold, can affect reported areas and must be defined in advance. Out-of-specification results trigger a structured investigation that may include reanalysis, instrument checks, and review of sample preparation. Regulatory inspections often examine raw data, audit trails, and training records to verify that reported results are traceable and reliable.
Method validation establishes that an HPLC procedure is suitable for its intended use. Key parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Accuracy measures agreement with a true or accepted value, while precision describes repeatability and intermediate precision. Specificity confirms that the method measures the analyte without interference from impurities, degradants, or excipients. Validation is documented in a protocol and report, and acceptance criteria are set before experiments begin. Regulatory guidance varies by region, but the general principles are widely harmonized.
== Stages of progress in nanotechnology == In 2005, Mihail Roco, one of the architects of the USA's National Nanotechnology Initiative, proposed four states of nanotechnology that seem to parallel the technical progress of the Industrial Revolution, of which productive nanosystems is the most advanced. 1. Passive nanostructures - nanoparticles and nanotubes that provide added strength, electrical and thermal conductivity, toughness, hydrophilic/phobic and/or other properties that emerge from their nanoscale structure. 2. Active nanodevices - nanostructures that change states in order to transform energy, information, and/or to perform useful functions. There is some debate about whether or not state-of-the art integrated circuits qualify here, since they operate despite emergent nanoscale properties, not because of them. Therefore, the argument goes, they don't qualify as "novel" nanoscale properties, even though the devices themselves are between one and a hundred nanometers. 3. Complex nanomachines - the assembly of different nanodevices into a nanosystem to accomplish a complex function. Some would argue that Zettl's machines fit in this category; others argue that modern microprocessors and FPGAs also fit. 4. Systems of nanosystems/Productive nanosystems - these will be complex nanosystems that produce atomically precise parts for other nanosystems, not necessarily using novel nanoscale-emergent properties, but well-understood fundamentals of manufacturing. Because of the discrete (i.e.
==== Developmental disorders ==== Hypospadias is a developmental disorder where the meatus is positioned wrongly at birth. Hypospadias can also occur iatrogenically by the downward pressure of an indwelling urethral catheter. It is usually corrected by surgery. A micropenis is a very small penis caused by developmental or congenital problems. Diphallia, or penile duplication (PD), is the rare condition of having two penises.
==== Mexico ==== On 23 November 2007, the use and trade of pseudoephedrine in Mexico was made illegal as it was argued that it was extremely popular as a precursor in the synthesis of methamphetamine.
Many human-made chemicals are derived from fossil fuels (such as petroleum or coal) in which 14C is greatly depleted because the age of fossils far exceeds the half-life of 14C. The relative absence of 14CO2 is therefore used to determine the relative contribution (or mixing ratio) of fossil fuel oxidation to the total carbon dioxide in a given region of Earth's atmosphere. Dating a specific sample of fossilized carbonaceous material is more complicated. Such deposits often contain trace amounts of 14C. These amounts can vary significantly between samples, ranging up to 1% of the ratio found in living organisms (an apparent age of about 40,000 years). This may indicate contamination by small amounts of bacteria, underground sources of radiation causing a 14N(n,p)14C reaction, direct uranium decay (though reported measured ratios of 14C/U in uranium-bearing ores would imply roughly 1 uranium atom for every two carbon atoms in order to cause the 14C/12C ratio, measured to be on the order of 10−15), or other unknown secondary sources of 14C production. The presence of 14C in the isotopic signature of a sample of carbonaceous material possibly indicates its contamination by biogenic sources or the decay of radioactive material in surrounding geologic strata. In connection with building the Borexino solar neutrino observatory, petroleum feedstock (for synthesizing the primary scintillant) was obtained with low 14C content.
In an effort to prevent incidents such as the disappearance of Malaysia Airlines Flight MH370, a new standard has been issued requiring all commercial aircraft to report their position every 15 minutes to air traffic controllers regardless of the country of origin. Introduced in 2016 by the ICAO, the regulation has no initial requirement for any new aircraft equipment to be fitted. The standard is part of a long-term plan, called the Global Aeronautical Distress and Safety System (GADSS), which will require new aircraft to be equipped with data broadcast systems that are in constant contact with air traffic controllers. The GADSS is similar to the Global Maritime Distress and Safety System (GMDSS) used for maritime safety.
Sources: en.wikipedia.org
=== Caesium === The Chernobyl accident released a large amount of caesium isotopes which were dispersed over a wide area. 137Cs is an isotope which is of long-term concern as it remains in the top layers of soil. Plants with shallow root systems tend to absorb it for many years. Hence grass and mushrooms can carry a considerable amount of 137Cs, which can be transferred to humans through the food chain. One of the best countermeasures in dairy farming against 137Cs is to mix up the soil by deeply ploughing the soil. This has the effect of putting the 137Cs out of reach of the shallow roots of the grass, hence the level of radioactivity in the grass will be lowered. Also the removal of top few centimeters of soil and its burial in a shallow trench will reduce the dose to humans and animals as the gamma rays from 137Cs will be attenuated by their passage through the soil. The deeper and more remote the trench is, the better the degree of protection. Fertilizers containing potassium can be used to dilute cesium and limit its uptake by plants. In livestock farming, another countermeasure against 137Cs is to feed to animals prussian blue. This compound acts as an ion-exchanger. The cyanide is so tightly bonded to the iron that it is safe for a human to consume several grams of prussian blue per day. The prussian blue reduces the biological half-life (different from the nuclear half-life) of the caesium. The physical or nuclear half-life of 137Cs is about 30 years. Caesium in humans normally has a biological half-life of between one and four months.
Repaglinide is an antidiabetic drug in the class of medications known as meglitinides, and was invented in 1983. Repaglinide is a medication used in addition to diet and exercise for blood sugar control in type 2 diabetes. The mechanism of action of repaglinide involves promoting insulin release from β-islet cells of the pancreas; like other antidiabetic drugs, a main side effect concern is hypoglycemia. It is sold by Novo Nordisk under the name of Prandin in the United States, Gluconorm in Canada, Surepost in Japan, Repaglinide in Egypt, and Novonorm elsewhere. In Japan it is produced by Dainippon Sumitomo Pharma.
=== From vitamers === Animals are auxotroph for this enzyme co-factor and require it or an intermediate to be supplemented, hence its classification as a vitamin, unlike MoCo or CoQ10 for example. PLP is synthesized from pyridoxal by the enzyme pyridoxal kinase (gene PDXK), requiring one ATP molecule. PDXK can also produce 5'-phosphates of the other vitamers (pyridoxine and pyridoxamine), with pyridoxine 5′-phosphate oxidase converting these alternative 5'-phosphates into PLP. PLP is made and metabolized in the liver. PLP and other vitamin B6 phosphates can be broken down by pyridoxal phosphatase, which removes the phosphate group.
=== Services sector === The two largest employers in the service sector are the Groupe Hospitalier du Havre with 4,384 staff and the City of Le Havre with 3,467 permanent employees. The city has long been home to many service companies whose activity is related to port operations: primarily the ship-owning companies and also the marine insurance companies. The headquarters of Delmas (transport and communications, 1,200 employees) and SPB (Provident Society Banking, insurance, 500 employees) have settled recently at the entrance to the city. The head office of Groupama Transport (300 employees) is also present. The transport sector is the largest economic sector in Le Havre with 15.5% of employment. Logistics occupies a large part of the population and the ISEL trains engineers in this field. Since September 2007 the ICC has welcomed local students in their first year in the relocated Europe-Asia campus of the Institute of Political Studies of Paris. Higher Education is represented by the University of Le Havre which employs 399 permanent professors and 850 lecturers as well as by engineering companies like Auxitec and SERO. There are many growth factors in the tourist industry: blue flag rating, World Heritage status from UNESCO, the label French Towns and Lands of Art and History, cruise ship development, a policy of value-creation from heritage, and the City of the Sea project. In January 2020 the city had 26 hotels with a total of 1,428 rooms. Le Havre is the seat of the Chamber of Commerce and Industry of Le Havre. It manages the Le Havre Octeville Airport.
Sambhunath De ; (1 February 1915 – 15 April 1985) was an Indian medical scientist and researcher, who discovered the cholera toxin, the animal model of cholera, and successfully demonstrated the method of transmission of cholera pathogen Vibrio cholerae.
Sources: en.wikipedia.org
It measures the presence and amount of one or more compounds in a liquid sample. Separation occurs in a column, and detection produces a signal proportional to concentration. Identification usually requires comparison with a known reference standard under the same conditions.
In most cases the sample is consumed or altered during analysis, though some detectors are non-destructive. Fractions can be collected after separation for further study. Repeated testing therefore requires additional sample.
Run times range from under a minute for fast methods to over an hour for complex separations. Sample preparation, equilibration, and data review add time. Throughput depends on instrument configuration and method requirements.
System suitability is typically performed before each batch or according to the validated method and laboratory procedure. Some long runs include periodic checks during analysis. The required frequency depends on regulatory expectations and method performance.